Fagor America CNC8070 - Manual (Page 335)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
DDSSETUP Li
st
o
f
dr
iv
e
s
14.
(S OFT V03.0 X )
301
14.2 List of drives
This service shows a list of Sercos drives connected to the CNC. For each drive, it
shows the name of the axis associated with it, its identifier and a short description
for it, such as software version, motor ID and the ID of the drive itself.
The command bar is located at the bottom of the window. See "14.3 Command bar"
on page 302.
This screen is the one shown by default when accessing the DDSSetup. It can also
be accessed from any other service using the relevant softkey.