Fagor America CNC8070 - Manual (Page 27)

CNC 8070
(S OFT V03.0 X )
XV
WARRANTY TERMS
All products manufactured or marketed by Fagor Automation has a warranty period of 12 months
from the day they are shipped out of our warehouses.
The mentioned warranty covers repair material and labor costs, at Fagor Automation facilities,
incurred in the repair of the products.
Within the warranty period, Fagor Automation will repair or replace the products verified as being
defective.
Fagor Automation is committed to repairing or replacing their products from the time they launch
them up to 8 years after they disappear from the product catalog.
It is entirely up to Fagor Automation to determine whether a repair is to be considered under
warranty.
Excluding clauses
The repair will take place at our facilities; therefore, all shipping expenses as well as travelling
expenses incurred by technical personnel are NOT under warranty even when the unit is under
warranty.
This warranty will be applied so long as the equipment has been installed according to the
instructions, it has not been mistreated or damaged by accident or negligence and has been
manipulated by personnel authorized by Fagor Automation.
If once the service call or repair has been completed, the cause of the failure is not to be blamed
ON the FAGOR product, the customer must cover all generated expenses according to current
fees.
No other implicit or explicit warranty is covered and FAGOR AUTOMATION shall not be held
responsible, under any circumstances, of the damage which could be originated.
Service contracts
Service and Maintenance Contracts are available for the customer within the warranty period
as well as outside of it.