Fagor America CNC8070 - Manual (Page 231)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
TOOL
AND MAGA
Z
INE TABLE
M
agazi
n
e
t
abl
e
9.
(S OFT V03.0 X )
197
9.6.3 Magazine information
The right panel shows different information about the status of the tool magazine and
the tool changer arm. This information is grouped as follows:
Magazine status
This area shows the operation being carried out in the magazine.
In standby: The magazine is in standby.
Loading: A tool is being loaded into the magazine.
Unloading: A tool is being unloaded from the magazine.
Change status
If the magazine is involved in a tool change at a given time, it shows the information
about the status of that change; the operation is carried out when executing an M06,
manager status (in execution or at rest) and the status of the change process (whether
it is in error or not).
Tools in the changer arm
This area shows which are the tools that occupy each claw (holder) of the changer.
It shows the number and size of each tool.
(A) Magazine status.
(B) Tool in the claws of the changer arm.
(C) Tool selected on the list.
(D) Magazine data.
A
B
C
D
The "Status" led informs the user whether the magazine is in an error state or not.
To eliminate the error condition, press the reset softkey in the magazine table.