Apple Motion 5.1.1 - Manual (Page 338)

Chapter 9 Behaviors 338
Tip: Ease In and Accelerate begin at the In point of the Link behavior; Ease Out and Decelerate
end at the Out point of the Link behavior. Therefore, you can trim the Link behavior in the
Timeline to specify where the ease or acceleration begins and/or ends.
•
Custom Mix: A slider, available when the Mix Over Time parameter is set to Custom Mix, that can
be animated to create a user-determined mix between the source and target parameter values.
•
Scale: A slider that specifies a value to be multiplied with the Source Parameter before it is
applied to the target.
•
Apply Link When: A pop-up menu that enables you to limit when values from the source are
applied to the target. There are five choices:
•
Any source value: No limits are placed on the source parameter values. An offset slider for
each setting associated with the source parameter appears at the bottom of the Behaviors
Inspector. If the source parameter has a single slider, such as Opacity, a single offset slider
appears. If the source parameter has multiple sliders, such as Position X-Y-Z, offset sliders for
each of those settings appear.
•
Source value above minimum: The link applies only when the source value exceeds a defined
minimum value. If the source value falls below the defined minimum, the link behavior
stops. When selected, the Clamp Source Values Within Range checkbox as well as offset
and minimum sliders for each setting associated with the source parameter appear at the
bottom of the Behaviors Inspector. If the source parameter has a single slider, such as drop
shadow Blur, an offset and a minimum slider appear for that setting. If the source parameter
has multiple sliders, such as Scale X-Y-Z, offset and minimum sliders appear for each of
those settings.
•
Source value below maximum: The link applies only when the source value stays below
a defined maximum value. If the source value exceeds the defined maximum, the link
behavior stops. When selected, the Clamp Source Values Within Range checkbox as well as
offset and maximum sliders for each setting associated with the source parameter appear
at the bottom of the Behaviors Inspector. If the source parameter has a single slider, such
as shape Roundness, an offset and a maximum slider appear for that setting. If the source
parameter has multiple sliders, such as Rotation X-Y-Z, offset and maximum sliders appear
for each of those settings.
•
Source value between min and max: The link applies only when the source value stays
within a defined range. If the source value falls below the defined minimum, or exceeds
the defined maximum, the link behavior stops. When selected, the Clamp Source Values
Within Range checkbox as well as offset, minimum, and maximum sliders for each setting
associated with the source parameter appear at the bottom of the Behaviors Inspector.
If the source parameter has a single slider, such as shape Feather, one set of three sliders
(offset, minimum, and maximum) appears for that setting. If the source parameter has
multiple sliders, such as Fill Color (red, green, blue), sets of three sliders appear for each of
those settings.
•
Source value outside min and max: The link applies only when the source value stays
outside of a defined range. If the source value falls above the defined minimum, or below
the defined maximum, the link behavior stops. When selected, the Clamp Source Values
Within Range checkbox as well as offset, minimum, and maximum sliders for each setting
associated with the source parameter appears at the bottom of the Behaviors Inspector.
If the source parameter has a single slider, such as outline Width, one set of three sliders
(offset, minimum, and maximum) appears for that setting. If the source parameter has
multiple sliders, such as Shear X-Y, sets of three sliders appear for each of those settings.
67% resize factor