Apple Motion 5.1.1 - Manual (Page 789)

Chapter 19 Filters 789
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Mirror filter applied
Parameters in the Inspector
•
Center: Sets the position of the center of the mirror. Drag the Center onscreen control to adjust
its value in the Canvas.
•
Angle: Sets the angle of the mirror’s orientation.
•
Repeat Border Pixels: Sets the edge pixels to repeat to fill in the remainder of the shape when
the Center and/or Angle parameters are offset from the center.
•
Mix: Sets the percentage of the original image to be blended with the distorted image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
Page Curl
Animates the image as if it is a page peeling away from the upper-left corner of the Canvas to
the lower-right corner.
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Page Curl filter applied
Parameters in the Inspector
•
Direction: Sets the animation of the page curl to Open or Close.
•
Angle: Defines the angle of the page turn. Alternatively, use the Angle onscreen control (the
small circle between the center circle and arrow) with the Rotate control (the arrow) to set
the direction of the page turn. For example, at an Angle value of 180 degrees, the page turn
begins along the right edge of the image.
67% resize factor