Apple Motion 5.1.1 - Manual (Page 821)

Chapter 19 Filters 821
Parameters in the Inspector
•
Center: Sets the position of the center of the kaleidoscope. Drag the Center onscreen control
to adjust its value in the Canvas.
•
Segment Angle: Sets the angle at the tip of each triangular tile. Drag the outer handle of the
onscreen control to adjust this value.
•
Offset Angle: Sets the rotation of the whole kaleidoscope. Values range from 0 to 360. Drag
the inner handle (between the center and outer handle) of the onscreen control to adjust
this value.
•
Partial Segments: Sets whether partial segments are used to complete the radius of the
kaleidoscope. When Partial Segments is deselected, segments may be distorted to map them
across the radius of the kaleidoscope with facets of equal size.
•
Mix: Sets the percentage of the original image to be blended with the filtered image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
Kaleidotile
Simulates looking through a kaleidoscope with rectangular facets. This filter is not automatically
animated, but by animating the Angle parameter you can simulate the effect of twisting the
kaleidoscope to rotate the image pattern.
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Kaleidotile filter applied
Parameters in the Inspector
•
Center: Sets the origin of the kaleidotile effect. Drag in the center of the onscreen control (the
box) to adjust this value in the Canvas.
•
Width: Sets the width of the panels of the kaleidotile effect. Drag the right or left center handle
of the onscreen control to adjust this value. Drag a corner handle to adjust the Width and
Height parameters simultaneously.
•
Height: Sets the height of each panel. Drag the top or bottom center handle of the
onscreen control to adjust this value. Drag a corner handle to adjust the Height and Width
parameters simultaneously.
•
Angle: Sets the angle of rotation of the panels. Drag a corner handle in an arc to adjust
this value.
•
Mix: Sets the percentage of the original image to be blended with the filtered image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
67% resize factor