Apple Motion 5.1.1 - Manual (Page 790)

Chapter 19 Filters 790
•
Rotation: Defines the rotation of the page turn. Alternatively, use the Rotation onscreen control
(the arrow) with the Angle control (the small circle between the center circle and arrow) to set
the direction of the page turn. For example, when Angle is set to 180 degrees and Rotation is
set to 130 degrees, the page turn begins along the upper-right corner of the image.
•
Radius: Defines the size of the page curl. The larger the value, the more subtle the curl.
•
Fade Out: Defines the image’s opacity over the page curl animation. When set to 1, the image
remains opaque throughout the animation. When set to 100, the image is transparent by the
end of the animation.
•
Shadow: Controls the darkness of the shadow that appears beneath the curling portion of
the image.
•
Highlight Color: Defines a highlighted color on the back of the page.
•
Back Color: Defines the color and opacity on the back of the page.
•
Animate: Turns animation of the page-turn effect on and off.
•
Percent: Defines the amount of curl in the static image when the Animate checkbox
is deselected.
•
Mix: Sets the percentage of the original image to be blended with the distorted image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
Poke
Distorts an image by bowing the top, bottom, and sides inward, and appears to push the object
into the Canvas at the specified Center point. As the value of the Amount parameter increases,
the more the sides bow in. The Black Hole filter has a similar effect but also removes part of the
image at the center point.
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Poke filter applied
Parameters in the Inspector
•
Center: Sets the position of the center of the poke. Drag the Center onscreen control to adjust
its value in the Canvas.
•
Radius: Sets the radius of the poke effect. The higher the value, the smaller the image appears.
Scale must be set to greater than 0 for the Radius parameter to have an effect.
•
Scale: Sets the scale of the distortion.
•
Mix: Sets the percentage of the original image to be blended with the distorted image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
67% resize factor