Recover from a failure_stop – Rockwell Automation 1755-OF8 GuardPLC Controller Systems User Manual
Page 116
116
Publication 1753-UM001C-EN-P - March 2010
Chapter 13 Controller Configuration and Modes of Operation
Recover From a Failure_Stop
If the controller is in Failure_Stop, you must restart the controller,
following the steps below.
1. If the controller is not online, you must go online first.
a. In the Hardware Management window, from the Online
menu, choose Control Panel .
b. Type the Administrator username and password on the login
dialog box.
2. Once online, from the Control Panel Extra menu, choose Reboot
Resource as shown below.
TIP
You can use the [Ctrl]+[A] shortcut to enter the default
username (Administrator) and password.
TIP
A Reboot Resource can be initiated only when the controller is
in Failure_Stop mode. If you attempt a restart while the
controller is in any other mode, an error message appears.