Set up factorytalk view studio machine edition, Software – Rockwell Automation 1755-OF8 GuardPLC Controller Systems User Manual
Page 206
Advertising
206
Publication 1753-UM001C-EN-P - March 2010
Chapter 18 Introduction to EtherNet/IP Communication
Set Up FactoryTalk View Studio Machine Edition Software
Follow these steps to setup FactoryTalk View Studio Machine Edition
software.
1. Open FactoryTalk View Studio software.
2. Add the RSLinx Enterprise server to your application.
3. On the Communications tab, verify that RSLinx Enterprise
software can browse and locate the GuardPLC controller.
Advertising
This manual is related to the following products: