Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 259)

Publication 1753-UM001C-EN-P - March 2010 259
Use the GuardPLC Controller as a Scanner Chapter 20
9. In RSLogix Guard PLUS! software, put the GuardPLC controller
into RUN mode.
The configuration is now complete and the I/O modules should
be working under the control of the GuardPLC controller.
10. To view the status of the connection in RSNetWorx for
EtherNet/IP software, click the Connection Status tab.
Every connection in the GuardPLC controller is listed on this
screen. Any non-working connections are also listed.
11. You can also verify the connection status in RSLogix Guard
PLUS! software.
a. Open the Control Panel by choosing Control Panel from the
Online menu.
b. Click the EIP tab.
c. Click the Connections Status tab.
For more information on the Control Panel, see Chapter 14 .