Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 134)

134 Publication 1753-UM001C-EN-P - March 2010
Chapter 14 Use the Control Panel to Monitor Status
These commands can be carried out by using the Multi Control Panel
buttons in the button bar.
Multi Control Panel Buttons
Button Command
Connect
Connects the programming software to the selected controller(s) after loss of communication or manual
disconnect.
After manual disconnect, a new login with password is required.
Disconnect
Disconnects the programming software from the selected controller(s).
Coldstart
Performs a coldstart on the selected controller(s).
Stop
Stops the selected controller(s).
Download
Loads the routine(s) into the selected controller(s). Prior to download, the code generator must have successfully
generated program code and the selected controller(s) must be in Stop mode.
Important: You cannot download a routine into a controller other than the one for which the logic was created.
Control Panel
Starts the control panel for the selected controller(s). This command can be carried out for a single controller by
choosing Online>Control Panel.
Diagnostics
Starts the diagnostics display for the selected controller(s). This command can be carried out for a single
controller by choosing Online>Diagnostics.
Force Editor
Starts the force editor for the selected controller(s). This command can be carried out for a single controller by
choosing Online>Force Editor.
Select All
Selects all controllers in the list.
Deselect
Deselects marked controllers.
Remove Controller
Removes the selected controller(s) from the list. Removing a controller from the Multi Control Panel also
disconnects the communication.