Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 212)

212 Publication 1753-UM001C-EN-P - March 2010
Chapter 18 Introduction to EtherNet/IP Communication
Writing Integers to the GuardPLC Controller from the PanelView
Plus Terminal
This example uses output assembly 121 and shows how two integers
can be written by the PanelView Plus terminal. Two INT tags,
toGuard_INT1 and toGuard_INT2, were used in the controller as
shown.
The numeric input objects write the two integers to the GuardPLC
controller. Tags N121:0 and N121:1 were used to match the output
assembly used in the GuardPLC controller. The GuardPLC controller
does not use the ‘N’; it is required for FactoryTalk View software.