Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 117)

Publication 1753-UM001C-EN-P - March 2010 117
Controller Configuration and Modes of Operation Chapter 13
If a routine has already been loaded in the controller when
Failure_Stop occurs, the controller goes to Stop/Valid_Configuration
after booting. If Autostart Enable is activated, the routine starts up
automatically.
If a routine has not been loaded in the controller when Failure_Stop
occurs, the controller goes to Stop/Invalid_Configuration after
booting.
Controller Configuration To enable the controller to perform its tasks, you have to configure
the controller. The parameters you specify are stored in the
nonvolatile RAM and in the flash file system of the communication
section of the controller.
To configure a controller, follow these steps.
1. In the Hardware Management Window, expand the
Configuration module.
2. Right-click Resource and choose Properties.
3. From the Type pull-down menu, choose your controller.
TIP
If the GuardPLC controller is in Stop/Invalid_Configuration after
booting, you need to update the SRS. From the Extra menu,
choose Change System ID (SRS). Enter the SRS and click OK.
TIP
A brand-new GuardPLC 1200 or 2000 controller, into which a
back-up battery has not yet been installed, is always in
Failure_Stop and must be restarted before you can download a
routine.