Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 203)

Publication 1753-UM001C-EN-P - March 2010 203
Introduction to EtherNet/IP Communication Chapter 18
Signal Connections
It is your responsibility to allocate assemblies to be of the desired
connection size. You do this by assigning signals, created in the Signal
Editor, to the scanner buffers or adapter assemblies.
For more information on creating signals by using the Signal Editor,
refer to the Using RSLogix Guard PLUS! Software with GuardPLC
Controllers Programming Manual, publication
1756-PM001 .
Software Required to Configure EtherNet/IP Communication
This table lists the software required to make EtherNet/IP connections.
Add EtherNet/IP Protocol to
the Resource 1. Expand the Resource folder in the project tree.
2. Right-click the Protocols folder under your Resource and choose
New>EtherNet/IP.
Function Software
communication RSLinx
EtherNet/IP Configuration RSNetWorx for EtherNet/IP
Programming Application Logic
RSLogix Guard PLUS!, Program Management,
version 4.1 or later
RSLogix Guard PLUS!, Hardware Management,
version 7.56.10 or later