Rockwell Automation 1755-OF8 GuardPLC Controller Systems - Manual (Page 237)

Publication 1753-UM001C-EN-P - March 2010 237
Use GuardPLC Controller as an Adapter Chapter 19
Configure an EtherNet/IP Driver
If you are going to program the PLC-5 or SLC 5/05 controller via the
EtherNet/IP network, you must configure an EtherNet/IP driver in
RSLinx software to allow your PC to communicate with the PLC-5 or
SLC 5/05 controller.
1. Start RSLinx software.
2. Click the Configure Drivers button.
3. From the Available Driver Types pull-down menu, choose the
Ethernet/IP Driver.
4. Click Add New.
5. Enter a name for the new driver and click OK.
Create an EtherNet/IP Project in RSLogix Programming Software
Use RSLogix 5 programming software for PLC-5 controllers and
RSLogix 500 programming software for SLC 5/05 controllers. Follow
these steps to create an EtherNet/IP project in RSLogix software.
1. Open the appropriate programming software.
2. From the File menu, choose New.