Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1090)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1074 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Titrando: 808, 809, 835, 836, 857, 904, 905, 906, 907
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command STDADD dos are configured on the
following 3 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Standard addition
Parameters for standard addition.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Standard addition curve
The standard addition curve with its associated evaluation data for a
determination is shown in the program part Database in the dialog win-
dow Calibration curve, which is opened with the menu item Determi-
nations
▶ Show calibration curve... or the symbol .
Command variables
The following command variables are generated in the method run by the
command STDADD dos and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used for
the command
.DBL Total duration for the processing of the command in s