Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1452)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1436 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
for ISE (+3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 21.7 mV
for ISE (-3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -17.7 mV
for ISE (+4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 16.8 mV
for ISE (-4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -12.8 mV
Intervention limits for slope (for pH and ISE electrodes only)
on | off (Default value: off)
If this option is activated, then the values for the slope will be shown in
red if the limits are exceeded.
Lower limit
Lower intervention limit for the slope.
for pH electrode
Range
-2.147E+9 ... 2.147E+9 %
Default value 95 %
for ISE (+1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 55 mV
for ISE (-1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -62.4 mV
for ISE (+2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 26.7 mV
for ISE (-2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -32.7 mV