Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1685)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual control
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1669
Swing rate
Swing rate for manual control of the Swing Head on the sample changer.
Range 10 ... 55 °/s
Default value 20 °/s
[Initialize rack]
The attached rack is initialized.
Note
When initializing the rack, the following actions are carried out:
– Rotate the rack in position to read out the rack code.
– Transfer the rack data for the rack code to the sample changer.
– Move lifts upwards to 0 mm.
– Move the robotic arm back.
8.4.4.3 Sample changer - Moving
Program part: Manual control
Here the moving to the desired rack, lift or robotic arm position can be
triggered manually.
Rack position
Set the rack position.
Current position
Shows the current rack position.
Target position
Selection or entry of the rack position to be moved to.
Range 1 ... n (depending on rack)
Default value 1
Selection Special beaker 1...16
Shift rate
Shift rate for manual control of the sample changer.
Range 5 ... 20 °/s
Default value 20 °/s