Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 679)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 663
Volume after EP
When the number of equivalence points defined under Stop EP has been
found, this volume will be added. In this way you can see the curve shape
after the equivalence point is reached.
Titrando, 855
Range
0.01000 ... 9999.99 mL
Selection off
Default value off
Stop time
Stops when the preset time (including start conditions) has elapsed since
the start of the titration.
Titrando, 855
Range
0 ... 999999 s
Selection off
Default value off
Filling rate
Speed with which the dosing cylinder is to be refilled after the titration.
The maximum filling rate depends on the cylinder volume of the exchange
unit or dosing device used.
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Range
0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
5.6.3.3.5.6 MET Upol - Potentiometric evaluation
Tab: Method ▶ MET Upol ▶ Properties... ▶ Potentiometric evaluation
Command name
Name of the command.
Input 25 characters
Parameters for the potentiometric evaluation of the titration curve with
automatic equivalence point recognition are defined on this tab. One of
the following three evaluation methods can be chosen here: