Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1712)

8.4 Manual control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1696 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Timeout
Time in seconds or minutes within which the action must have run
through completely. If this is not done after the maximum waiting time
has expired, the status of the stepping motor will be set to ERROR.
Range 0 ... 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.
Selection ACTIVE | INACTIVE | ERROR
[Start]
Sets the stepping motor to ACTIVE.
[Stop]
Sets the stepping motor to INACTIVE.
Reference position
On this tab the reference position of the stepping motor can be moved to.
Port description
Display of the port description.
Port
Display of the internal description of the port.
Type
Display of the port type.
Timeout
Time in seconds or minutes within which the action must have run
through completely. If this is not done after the maximum waiting time
has expired, the status of the stepping motor will be set to ERROR.
Range 0 ... 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.