Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1328)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1312 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Setpoint value
Setpoint value to which the control is to be set.
This parameter is not displayed for controller type = direct controller.
Range -214783647.000 ... 214783647.000 'Mapping
unit of the analog input or of the calculated
value'
Default value 'empty' or standard value from the selected
controller, respectively 'Mapping unit of the
analog input or of the calculated value'
Controlled variable
Display of the designation of the analog input port or of the calculated
value (formula entry).
This parameter is not displayed for controller type = direct controller.
Action
Selection of the controller action.
Selection Switch on | Switch off | Duration
Default value Switch on
Switch on
Switching on the control.
Switch off
Switching off the control.
Duration
Switching on the control during a defined time period.
Duration
Time duration during which controlling is to take place.
Range 0.0 ... 9999.9
Default value 10.0
Selection min | s
Default value s