Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1591)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Instruments
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1575
7.14.6 Properties - Oven
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Oven
On the tab Oven the oven parameters are set:
Oven program version
Shows the program version of the oven module.
Display for the 874 Oven Sample Processor only.
Oven serial number
Shows the serial number of the oven module.
Display for the 874 Oven Sample Processor only.
Initial temperature
Enter the initial temperature of the oven. Entering an initial temperature
means that the oven will heat up to the set temperature when it is
switched on. off means that the oven will not be switched on.
With the 774 Oven Sample Processor display of the initial temperature
set on the device only.
Range
50 ... 250 °C
Default value off °C
Max. temperature
With the 774 Oven Sample Processor display of the maximum tempera-
ture set on the device only.
With the 774 Oven Sample Processor display only.
Range
50 ... 250 °C
Default value 250 °C
Temperature correction
Enter the temperature correction. This parameter directly affects the tem-
perature control and allows it to be adjusted. In this way any temperature
difference that may occur between the oven and sample temperature can
be compensated.
With the 774 Oven Sample Processor display of the temperature correc-
tion set on the device only.
Range
-10 ... +10 °C
Default value 0 °C