Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1454)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1438 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
for ISE (+4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 17.8 mV
for ISE (-4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -11.8 mV
Warning limits for pH(0) (for pH electrodes only)
on | off (Default value: off)
If this option is activated, then the values for pH(0) will be shown in
orange if the limits are exceeded.
Lower limit
Lower warning limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 6.500
Upper limit
Upper warning limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 7.500
Intervention limits for pH(0) (for pH electrodes only)
on | off (Default value: off)
If this option is activated, then the values for pH(0) will be shown in red
if the limits are exceeded.
Lower limit
Lower intervention limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 6.000
Upper limit
Upper intervention limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 8.000