Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 471)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 455
Live display
on | off (Default value: on)
If this option is enabled, then the track will be shown in the live display.
Command variables
The following command variables are generated in the method run by the
command SERIE START and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.6.2.5 SERIES END
Dialog window: Method ▶ SERIES END ▶ Properties.. ▶ SERIES END 'Command
name'
Start command for series end track.
Appearance
The command has the following appearance:
Parameters
Command name
Name of the command.
Input 25 characters
Live display
on | off (Default value: on)
If this option is enabled, then the track will be shown in the live display.