Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1706)

8.4 Manual control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1690 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Graphical display
8.4.6.5 Analog outputs
8.4.6.5.1 Analog outputs - Overview
Program part: Manual control
If in the device tree the branch Analog outputs is selected, then all out-
puts can be commonly controlled on the tabs Set value and Set default
in the subwindow functions/parameters.
In the subwindow for the graphical display the adjacent value for all con-
nected analog outputs is shown in their physical order.
Setting a value
Value
Enter the value in % of the mapped range.
Range 0.0 ... 100.0 % Mapping
Default value 0.0 % Mapping
[Set]
Sets all analog outputs to the mapping value indicated.
Setting a default
[Set]
Resets all analog outputs to the default value in the configuration.
Graphical display
Example: