Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1314)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1298 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Identifi-
cation Description
.UNI Mapping unit which is defined in the configuration for an
IO port.
.[VAL] Value of the command variables (optional, i.e. Command
name.Port name' = Command name.Port
name.VAL'). The value returned corresponds to the status
of the IO port after completion of the command
5.6.11.4.2 ANALOG OUT - General
Tab: Method ▶ ANALOG OUT ▶ Properties... ▶ General
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type.
Selection IO Controller
Default value IO Controller
5.6.11.4.3 ANALOG OUT - Analog outputs
Tab: Method ▶ ANALOG OUT ▶ Analog outputs
Command name
Name of the command.
Input 25 characters