Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 66)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
50 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Designation Description Commands
.MR.MRS Standard deviation for mean dos-
ing rate for the whole range in
mL/min STAT, DOS
.MR.MRT Mean dosing rate for the whole
range in mL/min. STAT, DOS
.MTE Temperature measurement with
sensor; 1 = on, 0 = off) DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
Cond, CAL MEAS,
STDADD, DOS,
ELT MEAS
.NMP Number of measuring points in
measuring point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.OVE Value of the output at the end of
the command.
Direct controller/2-point-control-
ler: 1 = active, 0 = inactive
PID/PWM: -100 to 100% (value of
the analog output or the pulse
frequency)
CONTROL
.OVS Value of the output at the start of
the command.
Direct controller/2-point-controller
command status: 1 = active, 0 =
inactive
PID/PWM: -100 to 100% (value of
the analog output or the pulse
frequency)
CONTROL
.PK{x}.ABS Absorbance of the peak x (1…9)
in mAU MEAS Spec