Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1709)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual control
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1693
Switching on/off
[Start]
Sets all stepping motors to ACTIVE.
[Stop]
Sets all stepping motors to INACTIVE.
Graphical display
Example:
Dig-
Out_2_3_1
Type: Linear
drive
Status: ACTIVE
Dig-
Out_2_3_2
Type: Rotary
drive
Status: ACTIVE
Dig-
Out_2_3_3
Type: Rotary
drive
Status: INAC-
TIVE
Dig-
Out_2_3_4
Type: Linear
drive
Status: INAC-
TIVE
8.4.6.6.2 Stepping motor
Program part: Manual control
If in the device tree a single stepping motor is selected, then the stepping
motor can be controlled on the tabs Relative position, End position,
Absolute position, Reference position and Reset in the subwindow
for functions/parameters.
In the subwindow for the graphical display, the status of the stepping
motor and of the ports assigned is displayed.
Relative position
On this tab the position of the stepping motor can be modified by a value
defined relatively to the current position.
Port description
Display of the port description.
Port
Display of the internal description of the port.