Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1197)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1181
5.6.6.3.5 DOS U
5.6.6.3.5.1 DOS U - Overview
Dialog window: Method ▶ DOS U ▶ Properties... ▶ DOS U - 'Command name'
Command for controlled dosing with measured value U.
Devices
This command can be executed with the following devices:
Titrando: 835, 836, 842, 857, 902, 906, 907
Titrino: 718, 736, 751, 799
pH/Ion Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command DOS U are configured in the following
5 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Dosing parameters
Parameters for the dosing settings.
￭ Stop conditions
Definition of conditions which cause the stop of the dosing.
￭ Monitoring
Definition of measured value and temperature monitoring.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional columns in the measuring point
list.
Command variables
The following command variables are generated in the method run by the
command DOS U and can be used in formulas under the designation
'Command name.Variable designation':