Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1582)

7.13 864 Balance Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1566 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
815 Robotic USB Sample Processor XL, 855 Robotic Titrosampler, 864
Balance Sample Processor
Selection
196.0 mm
Default value 196.0 mm
Swing Head
This parameter is only shown when a swing head is mounted on the
tower.
Serial number
Shows the serial number of the swing head.
Swing position
Lift position valid for all 4 external positions, at which the swing head
turns to the external positions.
Range 0 ... 235 mm
Default value 0 mm
Rinse position
Rinse position valid for all 4 external positions.
Range 0 ... 235 mm
Default value 0 mm
[Configuration]
Opens the dialog window Configuration (see Chapter 7.11.7, page
1553) in which the properties of the robotic arm can be editet.
Table for external positions
The properties for the 4 possible external positions for the swing head
mounted on the tower are shown in the table. The table is not editable
directly.
External position
Number of the external position.
Angle [°]
Swing angle for external position.
Work position [mm]
Work position for external position.