Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1275)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1259
*******1 expects an active input line 0 (1 = set). For example, this line is
set by a Titrino after a titration has been completed and the Titrino can
accept a start signal again.
Note
Input lines that are of no interest or for which no defined condition can
be predicted should also be masked with an asterisk *.
Max. waiting time
on | off (Default value: off)
If this option is activated, then a maximum waiting time can be entered
for the input signal.
Range 0.0 ... 9999.9
Default value 10.0
Selection min | s
Default value min
Note
If the option Max. waiting time is not activated, it is being waited
endlessly for the input signal.
5.6.9.4 SEND
5.6.9.4.1 SEND - Overview
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command for Sending event messages to commands, tracks or to
tiamo.
Appearance
The command has the following appearance:
Parameters
The parameters for the command SEND are configured in the following
dialog window:
￭ SEND - Properties