Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 407)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 391
End value
End value for scaling the y1 axis.
Only editable when autoscaling is deactivated.
Range
-1.00E+12 ... +1.00E+12
Default value +1.00E+12
Curve
Curve color
Selection of a color for the line of the curve.
Selection 13 colors | blue
Default value blue
Symbol
Selection of the symbol for the display of the individual measuring points.
Selection ● | ╳ | ✸ | ￭ | ▲ | no symbol
Default value no symbol
no symbol
Measuring points are not shown.
Note
With curves, for which the distance between two measuring points is
smaller than 5 pixels, the individual measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can perhaps be enlarged in order to display the symbols again.
Symbol color
Selection of the color for the measuring point symbol.
Selection 13 colors | blue
Default value blue
Smoothing
Smoothing
on | off (Default value: on)
Activates/Deactivates smoothing for the curve.
Smoothing factor x axis
Factor for smoothing on the x axis.