Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 652)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
636 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Titrino
Range
0.000 ... 9999.99 mL
Default value 100.00 mL
Selection off
Stop measured value
Stops when the preset value for a measuring point has been exceeded or
not achieved since the start of the titration.
Titrando, 855
Range
-2000.0 ... 2000.0 mV
Selection off
Default value off
Titrino
Range
-2000 ... 2000 mV
Selection off
Default value off
Stop EP
The titration is stopped when the specified number of equivalence points
has been found.
Range 1 ... 9
Default value 9
Selection off
Volume after EP
When the number of equivalence points defined under Stop EP has been
found, this volume will be added. In this way you can see the curve shape
after the equivalence point is reached.
Titrando, 855
Range
0.01000 ... 9999.99 mL
Selection off
Default value off
Stop time
Stops when the preset time (including start conditions) has elapsed since
the start of the titration.
Titrando, 855
Range
0 ... 999999 s
Selection off
Default value off