Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1421)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1405
Range 1 ... 9
Default value 2
Dosing rate
Rate at which the solution is to be dosed. The maximum dosing rate
depends on the cylinder volume of the exchange unit used (see below).
When the function is carried out the rate will automatically be decreased
to the highest possible value.
Range 0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
Filling rate
Rate at which the cylinder is to be filled. The maximum filling rate depends
on the cylinder volume of the exchange unit used (see below). When the
function is carried out the rate will automatically be decreased to the
highest possible value.
Range 0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
Maximum dosing/filling rate for the exchange unit, depending on
the cylinder volume:
Cylinder volume maximum rate
1 mL 3.0 mL/min
5 mL 15.0 mL/min
10 mL 30.0 mL/min
20 mL 60.0 mL/min
50 mL 150.0 mL/min
Note
Enter lower rates for high-viscosity liquids.
Tubing parameters
Definition of the length and diameter of the tubing connected to the
exchange unit.