Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 431)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 415
Command without comment Command with comment
5.2.5 Checking a method
Menu item: Method ▶ File ▶ Method check
With the symbol or menu item File ▶ Method check a method check
for the method in focus is triggered. The following points are checked:
￭ Are the tracks defined in CALL commands available?
￭ Are the targets of loop commands defined?
￭ Are the variables defined in calculation formulas available?
￭ Does a track contain more than one command with conditioning acti-
vated?
￭ Does a special track (Series start track, Series end track, Exit track and
Error track) contain a command with conditioning activated?
A message is displayed for each error found. The method check has to be
started again afterwards. When the method check has been completed
successfully, it is confirmed with a message.
5.2.6 Saving a method
Menu item: Method ▶ File ▶ Save / Save as…
With the symbol or the menu item File ▶ Save an existing focused
method is saved again under its name without the window Save method
being opened.
When saving a newly created method with File ▶ Save or when saving
an existing method with File ▶ Save as... the dialog window Save
method is opened, in which the method group can be selected and a
method name can be entered or selected.
Method group
Method group
Selection of the method group where the method is to be stored (see
Chapter 5.4.1, page 430).
Selection Method groups | Main group
Default value Main group
Method table
The method table contains information about all methods of the selected
method group. The table cannot be edited. With a click on the column
title (columns Name, Saved, User, Full name, Version, Signed,