Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1098)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1082 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
5.6.4.19 STDADD auto
5.6.4.19.1 STDADD auto - Overview
Dialog window: Method ▶ STDADD auto ▶ Properties... ▶ STDADD auto - 'Com-
mand name'
Command for Standard addition with automatic addition of the stand-
ard addition solution from a dosing device in such a way that a constant
potential difference results.
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 857, 904, 905, 906, 907
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command STDADD auto are configured on the
following 3 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Standard addition
Parameters for standard addition.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Standard addition curve
The standard addition curve with its associated evaluation data for a
determination is shown in the program part Database in the dialog win-
dow Calibration curve, which is opened with the menu item Determi-
nations
▶ Show calibration curve... or the symbol .
Command variables
The following command variables are generated in the method run by the
command STDADD auto and can be used in formulas under the desig-
nation 'Command name.Variable designation':