Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 548)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
532 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Titrino
Range
0 ... 200
Default value 5
[New]
Open the dialog window Measured value window # in which the
parameters for a new window can be entered.
[Properties]
Open the dialog window Measured value window # in which the
parameters for the selected window can be edited (see Chapter
5.6.3.2.4.9, page 537).
[Delete]
Delete the window selected in the table.
Evaluation with volume window (mL)
[New]
Open the dialog window Volume window # in which the parameters
for a new window can be entered (see Chapter 5.6.3.2.4.10, page
538).
[Properties]
Open the dialog window Volume window # in which the parameters
for the selected window can be edited (see Chapter 5.6.3.2.4.10, page
538).
[Delete]
Delete the window selected in the table.
5.6.3.2.4.7 DET Ipol - Additional evaluations
Tab: Method ▶ DET Ipol ▶ Properties... ▶ Additional evaluations
Command name
Name of the command.
Input 25 characters
The following additional methods for evaluation of titration curves can be
activated and defined on this tab:
Fixed endpoint evaluation
Fixed endpoint evaluation
on | off (Default value: off)
If this check box is activated, then the associated values for the other
measured quantities will be interpolated with a fixed measured quantity