Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1202)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1186 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
exchange unit or dosing device used. If the entered filling rate is too high
for the selected dosing device, it will automatically be reduced during dos-
ing to the largest possible value.
Titrando, 855
Range
0.01 ... 166.00 mL/min
Default value maximum mL/min
Sensor
Measuring input
Selection of the measuring input to which the sensor is connected.
Titrando
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1
Titrino
Selection
1 | 2 | diff.
Default value 1
Sensor
Selection of a sensor of type pH electrode, metal electrode, pH elec-
trode or ISE electrode from the list of sensors defined in the sensor
table. The calibration data for the sensor will be adopted for pH and ISE
electrodes.
Selection Sensor name | pH electrode | Metal electrode |
ISE electrode
Default value Metal electrode
Temperature measurement
Type of temperature measurement.
Titrando, 855
Selection
continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.