Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 183)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 167
Name
Name of the sample table.
Saved
Date and time when the sample table was saved.
Saved by
Short name of the user who saved the sample table.
Lines
Number of lines in the sample table.
Comment
Comment on the sample table that was entered on the tab Comment as
comment concerning the sample table (see Chapter 3.3.2.6, page 125).
Saving sample table
Name
Name under which the sample table is to be saved.
Note
The name of the sample table must be unique throughout the entire cli-
ent/server system.
Input 50 characters
[Save]
Save the sample table under the desired name.
3.6.4.9.9 Run test
Menu item: Workplace ▶ Tools ▶ Run test
Note
In contrast to the Sample table test, which is only used to check
whether or not all sample data is correct, the Run test also checks the
required hardware.
Single determination
The menu item Tools
▶ Run test or the symbol is used to perform
the start test for the selected method. The precondition for this is that the
workplace is in READY status.