2 interpreting output signal display status, 3 output signal display example, Analog – Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Analog Voltage and Pulse Train Reference User Manual
Page 324
8 Monitor Displays (Un
)
8.5.2 Interpreting Output Signal Display Status
8-8
8.5.2 Interpreting Output Signal Display Status
The status of allocated signals is displayed on the 7-segment display on the panel operator.
Output terminals correspond to LED numbers as shown in the following table.
• When the output signal is in OFF status, the top segment (LED) is lit.
• When the output signal is in ON status, the bottom segment (LED) is lit.
Note: Input signals use the following circuit configuration.
• OFF: Transistor OFF
• ON: Transistor ON
Example
8.5.3 Output Signal Display Example
Output signals are displayed as shown below.
• When the ALM signal is OFF
Display LED
Number
Output Terminal Name
Signal Name
(Factory Setting)
1
CN1-31, -32
ALM
2
CN1-25, -26
/COIN or /V-CMP
3
CN1-27,
-
28
/TGON
4
CN1-29, -30
/S-RDY
5
CN1-37
ALO1
6
CN1-38
ALO2
7
CN1-39
ALO3
8
−
Reserved
4 3 2 1
Top: OFF
Bottom: ON
Number
6
7
8
5
Analog
ON: Transistor ON
The top segment of
number 1 is lit.
7 6
8
5 4 3 2 1
Analog