Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Analog Voltage and Pulse Train Reference - Manual (Page 399)

11.2 List of Parameters
11-23
11
Ap
pend
ix
Pn310
2 Vibration Detection Switch 0000 to 0002 − 0000 Immediately Setup −
Pn311 2
Vibration Detection
Sensibility
50 to 500 1% 100 Immediately Tuning
7.16
Pn312 2 Vibration Detection Level 0 to 5000 1 min
-1 50 Immediately Tuning
Pn324 2
Moment of Inertia Calculating
Start Level
0 to 20000 1% 300 Immediately Setup 6.3.2
Pn400 2 Torque Reference Input Gain 10 to100
0.1 V/
rated
torque
30 Immediately Setup
5.5.1
6.9.2
Pn401 2
Torque Reference Filter Time
Constant
0 to 65535
0.01 ms
100
Immediately Tuning 6.9.6
Pn402 2 Forward Torque Limit 0 to 800 1% 800 Immediately Setup
5.8.1
Pn403 2 Reverse Torque Limit 0 to 800 1% 800 Immediately Setup
Pn404 2 Forward External Torque Limit 0 to 800 1% 100 Immediately Setup 5.8.2,
5.8.4 Pn405 2 Reverse External Torque Limit 0 to 800 1% 100 Immediately Setup
Pn406 2 Emergency Stop Torque 0 to 800 1% 800 Immediately Setup 5.2.3
Pn407 2
Speed Limit during Torque
Control
0 to 10000 1 min -1 10000 Immediately Setup 5.5.4
(cont’d)
Parameter
No.
Size Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classification
Reference
Section
Vibration Detection Selection
Reference
Section
0 Does not detect vibration.
7.16 1 Outputs warning (A.911) when vibration is detected.
2 Outputs alarm (A.520) when vibration is detected.
Reserved (Do not change.)
Reserved (Do not change.)
Reserved (Do not change.)
4th 3rd 2nd 1st
digit digit digit digit
n.