Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Analog Voltage and Pulse Train Reference - Manual (Page 400)

11 Appendix
11.2.2 Parameters
11-24
Pn408
2
Torque Related Function
Switch
0000 to 1111 − 0000 − − −
Pn409 2 1st Notch Filter Frequency 50 to 5000 1 Hz 5000 Immediately Tuning
6.9.6
Pn40A 2 1st Notch Filter Q Value 50 to 1000 0.01 70 Immediately Tuning
Pn40B 2 1st Notch Filter Depth 0 to 1000 0.001 0 Immediately Tuning
Pn40C 2 2nd Notch Filter Frequency 50 to 5000 1 Hz 5000 Immediately Tuning
Pn40D 2 2nd Notch Filter Q Value 50 to 1000 0.01 70 Immediately Tuning
Pn40E 2 2nd Notch Filter Depth 0 to 1000 0.001 0 Immediately Tuning
Pn40F 2
2nd Step 2nd Torque Reference
Filter Frequency
100 to 5000 1 Hz 5000 Immediately Tuning
Pn410 2
2nd Step 2nd Torque Reference
Filter Q Value
50 to 100 0.01 50 Immediately Tuning
Pn412 2
1st Step 2nd Torque Reference
Filter Time Constant
0 to 65535 0.01 ms 100 Immediately Tuning 6.8.1
Pn415 2 T-REF Filter Time Constant 0 to 65535 0.01 ms 0 Immediately Setup 5.5.3
Pn423 2 Reserved (Do not change.) − − 0000 − − −
Pn424 2
Torque Limit at Main Circuit
Voltage Drop
0 to 100 1% 50 Immediately Setup
5.2.7
Pn425 2
Release Time for Torque Limit
at Main Circuit Voltage Drop
0 to 1000 1 ms 100 Immediately Setup
Pn456 2
Sweep Torque Reference
Amplitude
1 to 800 1% 15 Immediately Tuning 7.21
(cont’d)
Parameter
No.
Size Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classification
Reference
Section
1st Step Notch Filter Selection
When
Enabled
Classification
Reference
Section
0 N/A
Immediately Setup 6.9.6
1 Uses 1st step notch filter for torque reference.
Speed Limit Selection
When
Enabled
Classification
Reference
Section
0 Uses the smaller of the maximum motor speed and
the value of Pn407 as the speed limit value.
After restart Setup 5.5.4
1 Uses the smaller of the overspeed detection speed
and the value of Pn407 as the speed limit value.
2nd Step Notch Filter Selection
When
Enabled
Classification
Reference
Section
0 N/A
Immediately Setup 6.9.6
1 Uses 2nd step notch filter for torque reference.
Friction Compensation Function Selection
When
Enabled
Classification
Reference
Section
0 Disables friction compensation function.
Immediately Setup 6.8.2
1 Enables friction compensation function.
4th 3rd 2nd 1st
digit digit digit digit
n.