Altera IP Compiler for PCI Express - Manual (Page 119)

Chapter 5: IP Core Interfaces 5–33
Avalon-ST Interface
August 2014 Altera Corporation IP Compiler for PCI Express User Guide
and global routing resources used for the pld_clk, the Quartus II software may have
difficulty avoiding hold time violations on the tl_cfg_ctl_wr and tl_cfg_sts_wr
signals. If hold time violations occur in your design, you can reduce the multicycle
setup time for these signals to 0. The exact time the signals are clocked is not critical to
the design, just that the signals are reliably sampled. There are instruction comments
in the <variation_name>.sdc file about making these modifications.
Configuration Space Register Access
The tl_cfg_ctl signal is a multiplexed bus that contains the contents of configuration
space registers as shown in
Table 5–13 . Information stored in the configuration space
is accessed in round robin order where tl_cfg_add indicates which register is being
accessed.
Table 5–14 shows the layout of configuration information that is
multiplexed on tl_cfg_ctl.
Table 5–14. Multiplexed Configuration Register Information Available on tl_cfg_ctl (Note 1)
Address 31:24 23:16 15:8 7:0
0
cfg_devcsr[15:0]
cfg_dev2csr[15:0]
cfg_devcsr[14:12]=
Max Read Req Size (2)
cfg_devcsr[7:5]=
Max Payload (2)
1 cfg_slotcsr[31:16] cfg_slotcsr[15:0]
2 cfg_linkscr[15:0] cfg_link2csr[15:0]
3 8’h00 cfg_prmcsr[15:0] cfg_rootcsr[7:0]
4 cfg_seccsr[15:0] cfg_secbus[7:0] cfg_subbus[7:0]
5 12’h000 cfg_io_bas[19:0]
6 12’h000 cfg_io_lim[19:0]
7 8h’00 cfg_np_bas[11:0] cfg_np_lim[11:0]
8 cfg_pr_bas[31:0]
9 20’h00000 cfg_pr_bas[43:32]
A cfg_pr_lim[31:0]
B 20’h00000 cfg_pr_lim[43:32]
C cfg_pmcsr[31:0]
D cfg_msixcsr[15:0] cfg_msicsr[15:0]
E 8’h00 cfg_tcvcmap[23:0]
F 16’h0000 3’b000 cfg_busdev[12:0]
Note to Table 5–14 :
(1) Items in blue are only available for root ports.
(2) This field is encoded as specified in Section 7.8.4 of the PCI Express Base Specification .(3’b000–3b101 correspond to 128–4096 bytes).