Agilent Technologies Signal Analyzer N9030a - Manual (Page 1038)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Save
Both single and double quotes are supported for any filename parameter over remote.
After saving to a register, that register’s menu key is updated with the date and time of the save.
After saving to a register, you remain in the Save Trace menu, so that you can see the Register
key update. After saving to a file, the analyzer automatically returns to the previous menu and
any Save As dialog goes away.
Initial S/W Revision Prior to A.02.00
Data (Export)
Exporting a data file stores data from the current measurement to mass storage files. The Export
Menu only contains data types that are supported by the current measurement.
Since the commonly exported data files are in .csv format, the data can be edited by you prior to
importing. This allows youto export a data file, manipulate the data in Excel (the most common
PC Application for manipulating .csv files) and then import it.
Selecting an Export Data menu key will not actually cause the exporting to occur, since the
analyzer still needs to know where you wish to save the data. Pressing the Save As key in this
menu brings up the Save As dialog and Save As menu that allows you to specify the destination
file and directory. Once a filename has been selected or entered in the Open menu, the export will
occur as soon as the Save key is pressed.
Key Path Save
Mode All
Notes The menu is built from whatever data types are available for the mode. So the key locations in
the sub menu will vary.
No SCPI command directly controls the Data Type that this key controls. The Data Type is
included in the MMEM:STORe commands.
Dependencies If a file type is not used by a certain measurement, that type is grayed out for that measurement.
The key for a file type will not show at all if there are no measurements in the Mode that support
it.
Preset Is not affected by a Preset or shutdown, but is reset during Restore Mode Defaults
Readback The data type that is currently selected
Initial S/W Revision Prior to A.02.00
1038 Remote Language Compatibility Measurement Application Reference