Agilent Technologies Signal Analyzer N9030a - Manual (Page 195)

4 List of Legacy Analyzer Commands
Alphanumeric List of all Legacy Commands with N9061A Support
Command Description 8566 8568
8560
Series Description
memory
MOV Move No No No
MPY Multiply No No No
MRD Memory Read No No N/A
MRDB Memory read byte No No N/A
MSDEV Specifies mass storage
device N/A N/A No
MSI Mass storage interface N/A N/A N/A
MT0 Turns off marker signal
track Yes Yes Yes "MT0 [zero] (Marker Track Off)" on page 413
MT1 Turns on marker signal
track Yes Yes Yes "MT1 [one] (Marker Track On)" on page 414
MWR Memory Write No No N/A
MWRB Memory write byte No No N/A
MXM Maximum No No No
MXMH Max Hold Yes Yes Yes "MXMH (Maximum Hold)" on page 415
MXRMODE Mixer mode N/A N/A No
NDB Number of dB N/A N/A N/A
NDBPNT Turns the N dB points
function on or off N/A N/A N/A
NDBPNTR N dB points bandwidth N/A N/A N/A
NORMLIZE Normalize trace data N/A N/A Yes "NORMLIZE (Normalize Trace Data)" on page
416
NRL Normalized reference level N/A N/A Yes "NRL (Normalized Reference Level)" on page
418
NRPOS Normalized reference
position N/A N/A Yes "NRPOS (Normalized Reference Position)" on
page 419
NSTART Start harmonic No N/A N/A
NSTOP Stop harmonic No N/A N/A
O1 Output format Yes Yes N/A "O1 [one] (Format - Display Units)" on page
420
O2 Output format Yes Yes N/A "O2 [two] (Format - Two 8-Bit Bytes)" on page
421
Remote Language Compatibility Measurement Application Reference 195