Agilent Technologies Signal Analyzer N9030a - Manual (Page 622)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Input/Output
This key is grayed out in modes that do not support BTS.
Preset This is unaffected by a Preset but is set to 0 dB on a "Restore Input/Output Defaults" or
"Restore System Defaults->All"
State Saved Saved in instrument state.
Min –100 dB
Max 100 dB
Readback BTS, <Ext Gain value> dB
Initial S/W Revision Prior to A.02.00
Remote Command [:SENSe]:CORRection:BTS[:RF]:LOSS <rel_ampl>
[:SENSe]:CORRection:BTS[:RF]:LOSS?
Example CORR:BTS:LOSS 10 sets the Ext Gain value to –10 dB, and subsequently querying :LOSS will
give 10 dB
CORR:BTS:LOSS –10 sets the Ext Gain value to 10 dB, and subsequently querying :LOSS will give
–10 dB
Notes A positive value of <rel_ampl> in the above command means a loss and a negative value
indicates a gain.
Anytime :LOSS is set it sets :GAIN to the negative value of the parameter sent.
Anytime :LOSS is queried it gives the negative of :GAIN
Preset This is unaffected by a Preset but is set to 0 dB on a "Restore Input/Output Defaults" or
"Restore System Defaults->All"
Min 100 dB
Max –100 dB
Initial S/W Revision Prior to A.02.00
I Ext Gain
This function affects only the I channel input, except when the Input Path is I+jQ. In I+jQ this
setting is applied to both I and Q channel inputs. It is not available unless the Baseband I/Q
option (BBA) is installed.
Key Path Input/Output, External Gain
Remote Command [:SENSe]:CORRection:IQ:I:GAIN <rel_ampl>
[:SENSe]:CORRection:IQ:I:GAIN?
622 Remote Language Compatibility Measurement Application Reference