Agilent Technologies Signal Analyzer N9030a - Manual (Page 150)

3 Programming the Analyzer
STATus Subsystem
Mode All
Remote Command :STATus:QUEStionable:CALibration:SKIPped:ENABle <integer>
:STATus:QUEStionable:CALibration:SKIPped:ENABle?
Example STAT:QUES:CAL:SKIP:ENAB 1
Can be used to query if an EMI alignment skipped condition is detected
Preset 32767
Min 0
Max 32767
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Skipped Event Query
This query returns the decimal value of the sum of the bits in the Questionable Calibration Event
register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
Mode All
Remote Command :STATus:QUEStionable:CALibration:SKIPped[:EVENt]?
Example STAT:QUES:CAL:SKIP?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Skipped Negative Transition
This command determines which bits in the Questionable Calibration Skipped Condition register
will set the corresponding bit in the Questionable Calibration Skipped Event register when the
condition register bit has a negative transition (1 to 0). The variable <integer> is the sum of the
decimal values of the bits that you want to enable.
Mode All
Remote Command :STATus:QUEStionable:CALibration:SKIPped:NTRansition <integer>
150 Remote Language Compatibility Measurement Application Reference