Agilent Technologies Signal Analyzer N9030a - Manual (Page 756)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Marker Function
If the Measure at Marker window is being displayed, and one of the detectors is changed, any
value being displayed for that detector changes to “---“ until the next successful reading from that
detector.
Key Path Marker Function, Measure at Marker,
Remote Command :CALCulate:MAMarker:DETector[1] | 2 | 3 OFF | NORMal | AVERage |
POSitive | SAMPle | NEGative | QPEak | EAVerage | RAVerage
:CALCulate:MAMarker:DETector[1]|2|3?
Example : CALC:MAM:DET2 QPE
Sets the detector for measure at marker detector 2 to Quasi peak
:CALC:MAM:DET OFF
Sets the detector for measure at marker detector 1 to Off
State Saved Saved in instrument state
Initial S/W Revision A.02.00
Key Path Marker Function, Measure at Marker,
Remote Command :CALCulate:MAMarker:DETector[1]|2|3:DWELl <dwell time>
:CALCulate:MAMarker:DETector[1]|2|3:DWELl?
Example :CALC:MAM:DET2:DWEL 500 ms
Sets the detector for measure at marker detector 2 to dwell for 500 ms
State Saved Saved in instrument state
Backwards
Compatibility SCPI [:SENSe]:EMI:MEASure:DETector:DWELl <dwell time>
This command is included for compatibility with the E7400 and PSA option 239 . Sets all of the
detectors’ dwell times to the specified amount
Initial S/W Revision A.02.00
Detector 1
This menu lets you select the detector to be used for Detector 1, or turn Detector 1 off. This is a
1-of-N menu that shows the normal list of detectors, but with the “Auto” key replaced by “Off”.
Key Path Marker Function, Measure at Marker, Detectors
Remote Command See "Detectors" on page 755 .
Example :CALC:MAM:DET QPE
Sets the detector for measure at marker detector 1 to Quasi peak
:CALC:MAM:DET OFF
756 Remote Language Compatibility Measurement Application Reference