Agilent Technologies Signal Analyzer N9030a - Manual (Page 689)

6 RLC Swept SA Measurement Front-Panel & SCPI Reference
Marker
Key Path Marker
Notes The selected marker is remembered even when not in the Marker menu and is used if a Search
is done or a Band Function is turned on or for Signal Track or Continuous Peak.
Preset Marker 1
State Saved The number of the selected marker is saved in instrument state.
Initial S/W Revision Prior to A.02.00
Select Marker
Specifies the selected marker. The term “selected marker” is used throughout this document to
specify which marker will be affected by the functions.
Key Path Marker
Notes The selected marker is remembered even when not in the Marker menu and is used if a Search
is done or a Band Function is turned on or for Signal Track or Continuous Peak.
Preset Marker 1
State Saved The number of the selected marker is saved in instrument state.
Initial S/W Revision Prior to A.02.00
Relative To
Selects the marker that the selected marker will be relative to (its reference marker).
Every marker has another marker to which it is relative. This marker is referred to as the
“reference marker” for that marker. This attribute is set by the Marker, Properties, Relative To key.
The marker must be a Delta marker to make this attribute relevant. If it is a Delta marker, the
reference marker determines how the marker is controlled and how its value is displayed. A
marker cannot be relative to itself.
Key Path Marker, Properties
Remote Command :CALCulate:MARKer[1]|2|...12:REFerence <integer>
:CALCulate:MARKer[1]|2|...12:REFerence?
Example CALC:MARK1:REF 2 sets the marker 1 reference marker to 2 and turns marker 1 on as a delta
marker.
Notes A marker cannot be relative to itself so that choice is grayed out. If the grayed out key is pressed,
an advisory message is generated.
Notes This command causes the marker specified with the subopcode to become selected.
Remote Language Compatibility Measurement Application Reference 689