Agilent Technologies Signal Analyzer N9030a - Manual (Page 155)

3 Programming the Analyzer
STATus Subsystem
Remote Command :STATus:QUEStionable:CALibration:EXTended:NEEDed:CONDition?
Example STAT:QUES:CAL:EXT:NEED:COND?
Preset 0
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Needed Enable
This command determines which bits in the Questionable Calibration Extended Needed Condition
Register will set bits in the Questionable Calibration Extended Needed Event register, which also
sets bit 14 of the Questionable Calibration Register. The variable <integer> is the sum of the
decimal values of the bits you want to enable.
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:NEEDed:ENABle <integer>
:STATus:QUEStionable:CALibration:EXTended:NEEDed:ENABle?
Example STAT:QUES:CAL:EXT:NEED:ENAB 2
Can be used to query if an EMI conducted alignment is needed.
Preset 32767
Min 0
Max 32767
Status Bits/OPC dependencies Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Needed Event Query
This query returns the decimal value of the sum of the bits in the Questionable Calibration
Extended Needed Event register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:NEEDed[:EVENt]?
Example STAT:QUES:CAL:EXT:NEED?
Remote Language Compatibility Measurement Application Reference 155